Key Points For Checking Vibration System Of Mobile Brick Making Machine
Vibration system is an important part of block molding system. Vibration system is to a mobile brick making machine what water is to fish, so we should pay more attention to it in use and maintenance. Please pay attention to the following requirements to check the vibration system, if there is a problem may cause damage to the vibration system.
Please check the matter as below. Whether the bottom foot screw and universal coupling connection screw of Mobile brick making machine motor are loose. Whether the universal coupling is short of oil. Whether the swinging block is axial running and coincidence degree is consistent. Whether the vibrator is short of oil. Whether the bearing is short of oil and the rotation is flexible. Whether the vibrator is consistent with the table screw. Whether the high point of the leg is consistent. Whether the lower switch of the mould box is too low. Whether the vibration rubber block is effective. If the lubricating oil is not replaced every month in time, please reduce the pre-vibration frequency and increase the final vibration frequency.
Attention: Because the two vibration motors of the mobile brick making machine vibration system may have different speeds under the same frequency, which will cause the vibrator to mismatch on both sides of the vibration. It is the relatively fast speed hold the relatively slow operation to run, which will cause fast speed loss of the active shaft. In order to solve this problem. The frequency of fast speed can be reduced by 0.15~0.5 Hz according to the actual situation, so as to ensure that the actual working speed of the two vibration motors is the same, and then the active shaft of the vibrator on both sides can be matched.
